Improved the behaviour and response of the two screen encoders.Preset Auto Load Setting – Enable this setting (found in ‘Settings – General’ on the screen) to load patches, sequences and FX presets by scrolling and ‘hovering’ on a preset – no click required.Fixed bug in polychain mode where DIN Thru could still be active on polychain slaves, leading to undefined behaviour.Fixed an aftertouch to cutoff modulation scaling issue for classic filters. ![]() Fixed issue wheres some parameters would not be properly forwarded in polychain mode.Fixed issue where the first loop of the arpeggiator sequence may not contain all pressed notes when using the ‘backwards’ direction mode.Fixed a potential arpeggiator note ordering issue when playing arp patterns using a pendulum direction mode.Fixed a potential arpeggiator note ordering issue when playing arps with an arp octave value of 2 or more.The Type parameter page now displays both the graph and text value.Improved the graph to be a more accurate representation of the filter.Improved the screen’s filter graph / parameter pages in the following ways:.The Wave, Bank and WavMod parameter pages now display both the waveform and text value.The waveform display now has the selected WavMod processor applied to it.Improved the screen’s osc parameter pages / waveform display in the following ways:.Improved internal gain staging for increased output volume in most cases. ![]() N-Reverse Pendulum 2 – A reverse version of N-Pendulum 2.Reverse Pendulum 2 – A reverse version of Pendulum 2.N-Reverse Pendulum – A reverse version of N-Pendulum.Reverse Pendulum – A reverse version of Pendulum.N-Pendulum 2 – Pendulum 2 in note number order.Pendulum 2 – Repeats the last note when reversing direction.Osc Free Run – Emulating the behaviour of analogue oscillators by allowing them to run freely.Vintage Parameter – Emulating the behaviour of vintage synths by introducing variation between the voices.Sallen-Key – 2 pole resonant Sallen-Key Filter with pre-filter drive, morphing through: LP > BP.Ladder Phaser – Resonant ladder filter with pre-filter drive, morphing through: Notch > Phaser.Ladder Hybrid – 1 pole resonant ladder filter with pre-filter drive, morphing through: LP + Notch > Notch > HP + Notch.Ladder – 4 pole resonant ladder filter with pre-filter drive, morphing through: LP > BP > HP.4 New Filter Types: Distortion control is used to control filter drive when these types are active.Added 15 new FX including a new reverb algorithm:.Fixed very rare crash when sending certain tempo values from external MIDI.Fixed an arpeggiator chord mode issue where pressed notes may not all be added to the arp straight away.Fixed arpeggiator hanging notes issues potentially seen when using long divisions and gate lengths.Fixed an arpeggiator delay / latency issue introduced in version 3.0.Added a panel shortcut for the Osc Free Run parameter – hold the ‘Patch’ button and turn the Osc2 Tune control (the ‘Tune2/Fine2’ encoder on ARGON8 and ARGON8X, or the ’Tune/Fine’ encoder on ARGON8M).Bipolar – The same cutoff control scaling curve and portamento / glide / pitch bend tracking behaviour as the ‘Relative’ mode, except in this mode note-to-cutoff tracks best when the cutoff control is at 64.In this mode note-to-cutoff tracks best when the cutoff control is at 0, and tracks portamento / glide and pitch bend. Relative – A new cutoff control scaling curve that is more balanced and changes the note-to-cutoff tracking to behave more closely to analogue synths.Legacy – The existing cutoff control scaling curve and note-to-cutoff tracking behaviour. ![]()
0 Comments
Leave a Reply. |